Jeep Liberty: Auto Up Feature With Anti-Pinch Protection — If Equipped - Power Windows - Windows - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Auto Up Feature With Anti-Pinch Protection — If Equipped

On some models, the driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto Up” feature. Pull the window switch fully upward to the second detent, release, and the window will go up automatically.

To stop the window from going all the way up during the Auto Up operation, push down on the switch briefly.

To close the window part way, pull the window switch up to the first detent and release when you want the window to stop.

For vehicles not equipped with the Electronic Vehicle Information Center (EVIC), the power window switches will remain active for 45 seconds after the ignition switch is turned to the LOCK position. Opening either front door will cancel this feature.

For vehicles equipped with the EVIC, the power window switches will remain active for up to 10 minutes after the ignition switch is turned to the LOCK position. Opening either front door will cancel this feature. The time is programmable. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer-Programmable Features)” in “Understanding Your Instrument Panel” for further information.

NOTE:
• If the window runs into any obstacle during autoclosure, it will reverse direction and then go back down. Remove the obstacle and use the window switch again to close the window.

• Any impact due to rough road conditions may trigger the auto reverse function unexpectedly during autoclosure.

If this happens, pull the switch lightly to the first detent and hold to close window manually.

WARNING!
There is no anti-pinch protection when the window is almost closed. Be sure to clear all objects from the window before closing.

    Auto-Down Feature
    The driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto- Down” feature. Press the window switch past the first detent, release, and the wi ...

    Reset
    It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure: 1. Pull the window switch up to close the window completely and continue to ...

    See also:

    HomeLinkВ® Wireless Control System
    The HomeLinkВ® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are ...

    General information
    Adjusting the seat belt Seat belts should always be worn by all occupants of your vehicle. Children should be properly restrained, using an infant, car, or booster seat determined by age, wei ...

    Windows
    Power Window Controls (if equipped) Driver’s side The power windows can only be operated when the ignition switch is in the “ON” position. The driver’s door has switches (1), (2), (4), (5 ...