Jeep Liberty: Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be enabled or disabled as follows:
вЂў For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to вЂњElectronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)вЂќ in вЂњUnderstanding Your Instrument PanelвЂќ for further information.
вЂў For vehicles not equipped with the EVIC, perform the following procedure:
1. Close all doors and place the key in the ignition.
2. Cycle the ignition switch between OFF and ON/RUN and then back to OFF five times, ending up in the ON/RUN position.
3. Press the power door UNLOCK switch to unlock the doors.
4. A single chime will indicate the completion of the programming.
Repeat these steps if you want to return this feature to its previous setting.
NOTE: Use the Automatic Unlock Doors On Exit feature in accordance with local laws.
Anytime you store your vehicle, or keep it out of service (i.e., vacation) for two weeks or more, run the air conditioning system at idle for about five minutes in the fresh air and high blower ...
Examine tires for excessive tread wear and uneven wear patterns. Check for stones, nails, glass, or other objects lodged in the tread or sidewall. Inspect the tread for cuts and cracks. Inspect ...
Setting the compass
Determine your position using the following zone maps. North America zone map South America zone map Press a round pin into opening 3() for approximately three seconds. The currently ...