Jeep Liberty: Base System - Tire Pressure Monitor System (TPMS) - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: Base System

The Tire Pressure Monitor System (TPMS) uses wireless technology with wheel rim mounted electronic sensors to monitor tire pressure levels. Sensors, mounted to each wheel as part of the valve stem, transmit tire pressure readings to the receiver module.

NOTE: It is particularly important for you to check the tire pressure in all of the tires on your vehicle monthly and to maintain the proper pressure.

The TPMS consists of the following components:
• Receiver Module
• Four Tire Pressure Monitoring Sensors
• Tire Pressure Monitoring Telltale Light

The matching full-size spare wheel and tire assembly (if equipped) has a tire pressure monitoring sensor. The matching full-size spare can be used in place of any of the four road tires. The TPMS will only monitor the pressure in the full-size spare when it is used in place of a road tire. Otherwise, a spare with a pressure below the lowpressure limit will not cause the “Tire Pressure Monitoring Telltale Light” to illuminate or the chime to sound.

Tire Pressure Monitor System (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by about ...

Tire Pressure Monitoring Low Pressure Warnings
The “Tire Pressure Monitoring Telltale Light” will illuminate in the instrument cluster, a “LOW TIRE PRESSURE” message will display in the instrument cluster, and a chime will sound wh ...

See also:

Turning the System On and Off
The URPA system can be turned on and off using the infotainment system controls. See Vehicle Personalization on page 5‑33 for more information. When the system is off, PARK ASSIST OFF display ...

Power outlets
The power outlet can be used for a following component. 12 V: Accessories that use less than 10 A. 120 VAC: Accessories that use less than 100 W. ■ 12 V Type A Type B Type C σ ...

Removing/installing the headlamp cover
You must remove the headlamp cover in the engine compartment before you can replace the bulbs in the headlamp. To remove: press retaining clip 1 in the direction of the arrow. Pull cover 2 f ...