Jeep Liberty: Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage before you begin programming.
For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.
Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.
вЂў Erasing all channels should only be performed when programming HomeLink for the first time. Do not erase channels when programming additional buttons.
вЂў If you have any problems, or require assistance, please call toll-free 1вЂ“800вЂ“355вЂ“3515 or, on the Internet at www.HomeLink.com for information or assistance.
The park assist system is designed to assist you when driving into parking spaces, garages, etc. It utilizes ultrasound sensors in the front bumper and rear bumper(s) to measure the distance t ...
For information on how to handle and protect compact discs. ...
Turn signals When changing lanes 1 The driver can automatically flash the turn signals 3 times by moving the turn signal lever up or down to the first position and releasing it. When turning ...