Honda CR-V: Break-in Period

Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km).

During this period:

Avoid full-throttle starts and rapid acceleration.

Do not change the oil until the scheduled maintenance time.

Avoid hard braking for the first 200 miles (300 km).

Do not tow a trailer.

You should also follow these recommendations with an overhauled or exchanged engine, or when the brakes are replaced.

READ NEXT:

 Fuel Recommendation

Your vehicle is designed to operate on unleaded gasoline with a pump octane number of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic rapping noise that c

 Service Station Procedures

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

SEE MORE:

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter Crankshaft Pulley Holder Valve Guide Driver, 5.5 mm Attachment, 52 x 55 mm Driver Valve Spring Co

 PGM-FI System

Component Location Index CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST) OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR POWERTRAIN CONTROL MODULE (PCM) ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box) A/F SENSOR (LAF) RELAY (RELAY SOCKET E) IGNITION CO

В© 2016-2020 Copyright www.hcrv.net