Hyundai Tucson: Checking drive belts - Do-it-yourself maintenance - Hyundai Tucson Owner's ManualHyundai Tucson: Checking drive belts

Drive belts should be checked periodically for

Drive belts should be checked periodically for proper tension and adjusted if necessary. At the same time, belts should be examined for cracks, wear, fraying or other evidence of deterioration and replaced if necessary. Belt routing should also be checked to be sure there is no interference between the belts and other parts of the engine. After a belt is replaced, the new belt should be adjusted again after two or three weeks to eliminate slack resulting from initial stretching after use.

    Checking brake pedal clearance
    You need a helper to check the brake pedal clearance. With the engine running, have your helper press down on the brake pedal several times and then hold it down with a force of about 110 lb ...

    Checking and replacing fuses
    Replacing a Fusible Link A fusible link will melt if the electrical circuits from the battery are ever overloaded, thus preventing damage to the entire wiring harness. (This could be caused ...

    See also:

    Oil check preparation
    Prior to checking the oil level ensure that: - The vehicle is on level ground. - The engine oil is cold. Note: If it is necessary to check the oil level when the engine is hot, switch off the engi ...

    Control panel
    Control panel 1) Temperature control dial 2) Fan speed control dial 3) Airflow control dial 4) Control switch of the defogger and deicer system (Refer to “Defogger and deicer”.) 5) ...

    Tongue load
    Tongue load Ensure that the trailer tongue load is from 8 to 11 percent of the total trailer weight and does not exceed the maximum value of 200 lbs (90 kg). 1) Jack 2) Bathroom scal ...