Ford Escape: Erasing the Car2U Home Automation System buttons - Universal garage door opener (if equipped) - Driver Controls - Ford Escape Owner's ManualFord Escape: Erasing the Car2U Home Automation System buttons

Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used.

To erase programming on the Car2U system (individual buttons cannot be erased), use the following procedure:

1. Firmly press the two outside Car2U system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons.

2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased.

If you sell your vehicle equipped with the Car2U system, it is recommended that you erase the programming for security reasons.

FCC and RSS-210 Industry Canada Compliance

    Fixed code programming
    Note: Do not program the Car2U system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP swi ...

    FCC and RSS-210 Industry Canada Compliance
    The Car2U system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, ...

    See also:

    Attaching child safety seats with LATCH (Lower Anchors andTethers for CHildren) attachments
    The LATCH system is composed of three vehicle anchor points: two (2) lower anchors located where the vehicle seat back and seat cushion meet (called the “seat bight”) and one (1) top tether anch ...

    Removing the wheel cover
    Removing the wheel cover 1) Notch 2) Valve hole Insert a wheel cover remover into the notch part on the opposite side of the valve hole and pry the wheel cover to remove it. ...

    Headlamp
    1. Open the hood. 2. Reach behind the headlamp housing to access the headlamp bulb lock ring. 3. Firmly grasp the lock ring and rotate it counterclockwise to unlock it. 4. Remove the bulb and c ...