Jeep Liberty: Flash-To-Pass - Lights - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Flash-To-Pass

You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.

NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...

    Instrument Panel Dimmer
    Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights and prevent the interior lights from illuminating when a door is opened. Rotate th ...

    See also:

    Tire pressure monitoring system (TPMS) (U.S.-spec. models)
    The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pr ...

    Sunroof (if equipped)
    You can tilt or slide the sunroof by operating the “TILT” part of the sunroof switch or the “SLIDE” part of the sunroof switch when the ignition switch is in the “ON” position. There i ...

    Audio main operation
    Head unit: The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback. ONВ·OFF/Volume control: Place the ignition switch in the A ...