Jeep Liberty: Front Fog Lamp - Bulb Replacement - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Front Fog Lamp

1. Open the hood.

2. Reach behind the headlamp housing to access the bulb.

3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing.

4. Pull the bulb out of the socket and insert the replacement bulb.

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

5. Install the bulb and socket assembly into the into the fog lamp housing, and rotate the connector clockwise to lock it in place.

6. Close the hood.

    Front Turn Signal And Front Side Marker Lamp
    1. Turn the steering wheel all the way to the right to access the left front turn signal or side marker. Turn the steering wheel all the way to the left to access the right front turn signal or ...

    Rear Tail/Stop, Turn Signal, And Back-Up Lamp
    1. Open the liftgate. 2. Remove the screws that fasten the taillamp housing to the vehicle. 3. Pull the taillamp housing straight back to separate it from the vehicle. 4. Disconnect the elect ...

    See also:

    Changing engine coolant
    Major cooling system repairs should be performed by a NISSAN dealer. The service procedures can be found in the appropriate NISSAN Service Manual. Improper servicing can result in reduced hea ...

    Retained Accessory Power (RAP)
    These vehicle accessories can be used for up to 10 minutes after the engine is turned off: ○ Audio System ○ Power Windows ○ Sunroof (if equipped) Power to the audio system will ...

    Folding second seats
    Folding down the second seats will enlarge the luggage compartment. ■ Before folding the second seats 1 Stow the second center seat belt. Make sure the outside seat belt passes through the ...