Jeep Liberty: Headlight Time Delay вЂ” If Equipped
This feature is particularly useful when exiting your vehicle in an unlit area. It provides the safety of headlight illumination for about 90 seconds after turning the ignition switch to the LOCK position.
To activate the delay, turn the ignition switch to the LOCK position while the headlights are still on. Then, turn off the headlights within 45 seconds. The delay interval begins when you turn off the headlights. Only the headlights will illuminate during this time.
If you turn the headlights, or parking lights, or ignition switch ON again, the system will cancel the delay.
If you turn the headlights off before the ignition, they will turn off in the normal manner.
The Headlight delay time is programmable on vehicles equipped with the Electronic Vehicle Information Center (EVIC). Refer to вЂњElectronic Vehicle Information Center (EVIC)/Customer-Programmable FeaturesвЂќ in вЂњUnderstanding Your Instrument PanelвЂќ for further information.
Many markings (e.g. Tire size, Tire Identification Number or TIN) are placed on the sidewall of a tire by tire manufacturers. These markings can provide you with useful information on the ti ...
To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...
Passenger compartment fuse panel
The fuse panel is located on the right-hand side of the center console, by the instrument panel. Remove the panel cover to access the fuse cover. Press the tabs on the top and bottom of the fus ...