Jeep Liberty: Jacking Instructions
Carefully follow these tire changing warnings to help prevent personal injury or damage to your vehicle:
вЂў Always park on a firm, level surface as far from the edge of the roadway as possible before raising the vehicle.
вЂў Turn on the Hazard Warning flasher.
вЂў Block the wheel diagonally opposite the wheel to be raised.
вЂў Set the parking brake firmly and set an automatic transmission in PARK; a manual transmission in REVERSE.
вЂў Never start or run the engine with the vehicle on a jack.
вЂў Do not let anyone sit in the vehicle when it is on a jack.
вЂў Do not get under the vehicle when it is on a jack.
вЂў Only use the jack in the positions indicated and for lifting this vehicle during a tire change.
вЂў If working on or near a roadway, be extremely careful of motor traffic.
Jack Warning Label
Do not attempt to raise the vehicle by jacking on locations other than those indicated in the Jacking Instructions for this vehicle.
1. Remove spare tire.
2. Remove jack and tools from mounting bracket. Assemble the tools by connecting the driver to the extension, and then to the lug wrench.
3. Loosen (but do not remove) the wheel lug nuts by turning them to the left one turn while the wheel is still on the ground.
4. Locate the jack as shown. For the front tires, place it (rearward) of the notch on the body weld seam behind wheel to be changed.
Front Jacking Location
For the rear tires, place it under the axle by the wheel to be changed.
Rear Jacking Location
Position the jack handle on the jack. Do not raise the vehicle until you are sure the jack is fully engaged.
5. Raise the vehicle by turning the jack screw to the right.
Raise the vehicle only until the tire just clears the surface and enough clearance is obtained to install the spare tire.
Minimum tire lift provides maximum stability.
Raising the vehicle higher than necessary can make the vehicle less stable and cause a collision. It could slip off the jack and hurt someone near it. Raise the vehicle only enough to remove the tire.
6. Remove the lug nuts and wheel.
7. Position the spare wheel/tire on the vehicle and install lug nuts with the cone-shaped end toward the wheel.
Lightly tighten the nuts.
Be sure to mount the spare tire with the valve stem facing outward. The vehicle could be damaged if the spare tire is mounted incorrectly.
Mounting Spare Tire
To avoid the risk of forcing the vehicle off the jack, do not tighten the wheel nuts fully until the vehicle has been lowered.
8. Lower the vehicle by turning the jack screw to the left, and remove the jack.
9. Finish tightening the lug nuts. Push down on the wrench while at the end of the handle for increased leverage. Tighten the lug nuts in a star pattern until each nut has been tightened twice. The correct wheel nut tightness is 95 ft lb (130 NВ·m). If in doubt about the correct tightness, have them checked with a torque wrench by your authorized dealer or at a service station.
10. Lower the jack to itвЂ™s fully closed position.
11. Secure the tire, jack, and tools in their proper locations.
A loose tire or jack, thrown forward in a collision or hard stop, could endanger the occupants of the vehicle.
Always stow the jack parts and the spare tire in the places provided.
12. Remove blocks from wheels.
Voice Control Tips
Air or wind noise fromthe dashboard and side vents and all windows may interfere with the microphone. Adjust or close them as necessary. Press and release the HFL Talk button each time yo ...
The LED ambient lighting can be adjusted for colour and intensity via the touch screen. The exterior lamps must be turned on while changes are being made via the touch screen. See 104, TOUCH SCREE ...
Auxiliary power sockets
Auxiliary power sockets Only use Land Rover approved accessories. Using any other equipment may damage the vehicle's electrical system and/or cause battery discharge. If you are in any doubt ...