Jeep Liberty: Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Driver Memory Seat — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Linking And Unlinking The Remote Keyless Entry Transmitter To Memory

Your Remote Keyless Entry (RKE) transmitters can be programmed to recall one of two pre-programmed memory profiles with a press of the UNLOCK button on the RKE transmitter.

To program your RKE transmitters, perform the following:

1. Remove the key from the ignition.

2. Select the desired memory profile 1 or 2.

3. Press and release the SET button on the memory switch, then within five seconds press and release the side of the rocker switch labeled 1 or 2 accordingly.

Memory Profile Set” (1 or 2) will display in the EVIC, if equipped.

4. Press and release the LOCK button on the RKE transmitter within 10 seconds.

NOTE: Your RKE transmitters can be unlinked to the memory setting by pressing the SET button followed by the UNLOCK button on the RKE transmitter in Step 4 above.

    Programming The Memory Feature
    To create a new memory profile, perform the following: NOTE: Saving a new memory profile will erase an existing profile from memory. 1. Turn the ignition ON. 2. Adjust all memory profile settings ...

    Memory Position Recall
    NOTE: • For vehicles equipped with an automatic transmission, the vehicle must be in PARK to recall memory positions. If a recall is attempted when the vehicle is not in PARK, a message will ...

    See also:

    Replacement of light bulbs
    Before attempting to replace a light bulb, be sure the switch is turned to the "OFF" position. The next paragraph shows how to reach the light bulbs so they may be changed. Be sure to ...

    Sky Sliderв„ў Usage Precautions
    NOTE: • The system will not operate when ambient temperature is at –4°F (–20°C) or lower. • The system will not operate at vehicle speeds of 86 mph (138 km/h) or above. • Opening a ...

    Left control panel
    ...