GMC Terrain: Memory Seats
On vehicles with the memory feature, the вЂњ1вЂќ and вЂњ2вЂќ buttons on the outboard side of the driver seat are used to manually save and recall the driver seat and outside mirror positions. These manually stored positions are referred to as Button Memory positions.
The vehicle will also automatically save driver seat and outside mirror positions to the current driver Remote Keyless Entry (RKE) transmitter when the ignition is turned off. These automatically stored positions are referred to as RKE Memory positions. See Remote Keyless Entry (RKE) System Operation on page 2‑3 for more information.
Storing Button Memory Positions To save positions into Button Memory:
1. Adjust the driver seat, seatback recliner, and both outside mirrors to the desired driving positions.
2. Press and hold MEM (Memory) and вЂњ1вЂќ at the same time until a beep sounds.
3. Repeat Steps 1 and 2 for a second driver using вЂњ2.вЂќ
Recalling Button Memory Positions
To recall the manually saved Button Memory positions, press and hold вЂњ1вЂќ or вЂњ2.вЂќ The driver seat and outside mirrors move to the positions stored to those buttons when pressed. Releasing вЂњ1вЂќ or вЂњ2вЂќ before the stored positions are reached stops the recall.
If something has blocked the driver seat while recalling a memory position, the recall may stop. Remove the obstruction; then press and hold the appropriate manual control for the memory item that is not recalling for two seconds. Try recalling the memory position again by pressing the appropriate memory button. If the memory position is still not recalling, see your dealer for service.
Recalling RKE Memory Positions (Memory Remote Recall)
The Memory Remote Recall feature can recall the driver seat and outside mirrors to previously stored RKE Memory positions when entering the vehicle.
Every time the ignition is turned off, the positions of the driver seat and outside mirrors are automatically stored to the RKE transmitter that was used to start the vehicle. These positions are called RKE Memory positions and may be different than the previously mentioned Button Memory positions saved to the вЂњ1вЂќ or вЂњ2вЂќ buttons. To automatically recall RKE Memory positions, unlock the driver door with the RKE transmitter and open the driver door. If the driver door is already open, pressing the RKE transmitter button will also activate the RKE Memory recall. The driver seat and outside mirrors will move to the previously saved RKE Memory positions.
This feature is turned on or off using the vehicle personalization menu. See Vehicle Personalization on page 5‑33 for more information.
To stop recall movement, press any of the memory, power mirror, or power seat controls.
If something has blocked the driver seat while recalling a memory position, the recall may stop. Remove the obstruction; then press and hold the appropriate manual control for the memory item that is not recalling for two seconds. Try recalling the memory position again by opening the driver door and pressing the RKE button. If the memory position is still not recalling, see your dealer for service.
The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate. 1. Set the temperature to the lower limit. 2 ...
Detecting the Vehicle Ahead
The green vehicle ahead indicator will appear when a vehicle is detected ahead. Whenever this indicator does not appear, FCA will not respond. The indicator may disappear on curves, highway exit ...
Tilt/telescopic steering wheel
- Do not adjust the steering wheel tilt/telescopic position while driving. This may cause loss of vehicle control and result in personal injury. - If the lever cannot be raised to the fi ...