Jeep Liberty: Mode Control (Air Direction)
Rotate this control to choose from several patterns of air distribution. You can select either a primary mode as identified by the symbols on the control, or a blend of two of these modes.
The closer the setting is to a particular symbol, the more air distribution you receive from that mode.
Air is directed through the outlets in the instrument panel. These outlets can be adjusted to direct airflow.
NOTE: The center instrument panel outlets can be aimed so that they are directed toward the rear seat passengers for maximum airflow to the rear.
Air is directed through the panel and floor outlets.
NOTE: For all settings, except full cold or full hot, there is a difference in temperature between the upper and lower outlets. The warmer air flows to the floor outlets.
This feature gives improved comfort during sunny but cool conditions.
Air is directed through the floor outlets with a small amount flowing through the defrost and side window demist outlets.
Air is directed through the floor, defrost, and side window demist outlets. This setting works best in cold or snowy conditions that require extra heat to the windshield. This setting is good for maintaining comfort while reducing moisture on the windshield.
Air is directed through the windshield and side window demist outlets. Use this mode with maximum blower and temperature settings for best windshield and side window defrosting.
вЂў The air conditioning compressor operates in Mix, Defrost, or a blend of these modes, even if the Air Conditioning (A/C) button is not pressed. This dehumidifies the air to help dry the windshield. To improve fuel economy, use these modes only when necessary.
вЂў For information on operating the Rear Defrost, refer to вЂњRear Window FeaturesвЂќ in вЂњUnderstanding The Features Of Your VehicleвЂќ.
Pressing the Recirculation Control button will put the system in recirculation mode. This can be used when outside conditions such as smoke, odors, dust, or high humidity are present.
Activating recirculation will cause the LED in the control button to illuminate. After ten minutes, the system will return to normal mode function and the LED will turn off.
вЂў Continuous use of the Recirculation mode may make the inside air stuffy and window fogging may occur.
Extended use of this mode is not recommended.
вЂў The use of the Recirculation mode in cold or damp weather will cause windows to fog on the inside, because of moisture buildup inside the vehicle. Select the outside air position for maximum defogging.
вЂў The A/C will engage automatically to prevent fogging when the recirculation button is pressed and the mode control is set to panel or panel / floor.
вЂў The A/C can be deselected manually without disturbing the mode control selection.
вЂў When the ignition switch is turned to the LOCK position, the recirculation feature will be cancelled.
Folding Before folding the rear seats: - Secure the seat belts on the seat belt hooks on the side wall. (See вЂњSeat belt hooksвЂќ later in this section.) - Release the connector tongue of t ...
WARNING: When the engine is running, keep hands, hair, clothing, tools, etc. away from the moving fan and drive belts. Make sure the drive belt tension is correct. If the belt is too loose, insuff ...
Emissions control system maintenance
The Scheduled Maintenance services listed in bold type must be done at the times or mileages specified to ensure the continued proper functioning of the emissions control system. These and all o ...