Jeep Liberty: Normal Starting - Starting Procedures - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: Normal Starting

NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.

Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

Tip Start Feature

Turn the ignition switch to START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds. If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    Starting Procedures
    Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING! • When leaving the vehicle, always remove the key fob from the ign ...

    Extreme Cold Weather (Below –20°F Or –29°C)
    To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from your authorized dealer) is recommended. ...

    See also:

    Coolant level check
    Running the engine without coolant will cause serious engine damage. The coolant level in the expansion tank should be checked at least weekly (more frequently in high mileage or arduous operat ...

    Side lamps (green)
    Side lamps (green) Illuminates when the side lights are switched on. ...

    Drinking and driving
    WARNING Drinking and driving and/or taking drugs and driving are very dangerous combinations. Even a small amount of alcohol or drugs can affect your reflexes, perceptions and judgment. The ...