Jeep Liberty: Oil Change Required - Electronic Vehicle Information Center (EVIC) — If Equipped - Understanding Your Instrument Panel - Jeep Liberty Owner's ManualJeep Liberty: Oil Change Required

Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Required” message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.

Unless reset, this message will continue to display each time you turn the ignition switch to the ON position. To turn off the message temporarily, press and release the SELECT button. To reset the oil change indicator system (after performing the scheduled maintenance), perform the following procedure:

1. Turn the ignition switch to the ON position. Do not start the engine.

2. Fully depress the accelerator pedal slowly three times within 10 seconds.

3. Turn the ignition switch to the LOCK position.

NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.

    Electronic Vehicle Information Center (EVIC) Displays
    When the appropriate conditions exist, the EVIC displays the following messages: • Low Tire Pressure • Spare Low Pressure • Premium TPMS Graphic Display • Key in Ignition • Turn ...

    EVIC Main Menu
    To step to each main menu feature press and release the MENU button once for each step. A step from the last item in the list will cause the first item in the feature list to be displayed. The f ...

    See also:

    Deleting the phonebook data
    1. Select the “DELETE ENTRY” menu. 2. Select the phone number by performing either of the following procedures. – Operate the “TUNE/TRACK/CH” dial – Press the talk switch and say ...

    Front Seat Heater (if equipped)
    Front Seat Heater (if equipped) With the ignition switch in the “ON” position, push in one or both of the seat heater switches to warm the corresponding seat(s). The indicator light below th ...

    Type B audio set (if equipped)
    Type B audio set (if equipped) The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. - Power and audio controls: refer to page - Radio operation: ...