Jeep Liberty: Rain Sensing Wipers вЂ” If Equipped
This feature senses moisture on the windshield and automatically activates the wipers for the driver. This feature is especially useful for road splash or overspray from the windshield washers of the vehicle ahead. Rotate the end of the windshield wiper/washer control lever to one of the five intermittent wiper settings to activate this feature.
The sensitivity of the system is adjustable from the windshield wiper/washer control lever. Wiper delay position 1 is the least sensitive and wiper delay position 5 is the most sensitive. Choose position 3 for normal rain conditions. Choose position 2 or 1 if you desire less wiper sensitivity. Choose position 4 or 5 if you desire more sensitivity. Place the lever in the off position when not using the system.
вЂў The rain-sensing feature will not operate when the wiper speed is in the low or high position.
вЂў The rain-sensing feature may not function properly when ice or dried salt water is present on the windshield.
вЂў Use of Rain-X or products containing wax or silicone may reduce rain sensor performance.
вЂў The rain-sensing feature can be turned on and off through the Electronic Vehicle Information Center (EVIC) вЂ” if equipped. Refer to вЂњElectronic Vehicle Information Center (EVIC)/Personal Settings (Customer-Programmable Features)вЂќ in вЂњUnderstanding Your Instrument PanelвЂќ for further information.
The rain-sensing system has protective features for the wiper blades and arms. It will not operate under the following conditions:
вЂў Low Temperature Wipe Inhibit вЂ” The rain-sensing feature will not operate when the ignition is first switched ON, the vehicle is stationary, and the outside temperature is below 32В° F (0В° C). If the wiper control is moved, the vehicle speed becomes greater than 0 mph (0 km/h), or the outside temperature rises above freezing the rain-sensing feature will then operate.
вЂў Neutral Wipe Inhibit вЂ” The rain-sensing feature will not operate when the ignition is ON, and the shift lever is in the NEUTRAL position, and the vehicle speed is less than 5 mph (8 km/h), unless the wiper control is moved or the shift lever is moved out of the NEUTRAL position.
вЂў Remote Start Wipe Inhibit (Vehicles Equipped with Remote Start System) вЂ” The rain-sensing feature will not operate when the vehicle is in remote start mode.
This feature will return to normal operation once remote start mode is exited. Refer to вЂњRemote Start SystemвЂќ in вЂњThings To Know Before Starting Your VehicleвЂќ for further information.
Interrupting automatic opening/closing
Automatic opening or closing the tailgate can be interrupted in four ways: вЂў By pressing the button on the lighting panel. вЂў By pressing the button on the remote key. вЂў By pressing th ...
Registering by phone
1. Select the вЂњBY PHONEвЂќ menu. 2. Select the вЂњCONFIRMвЂќ menu. Then вЂњTRANSFERвЂќ is displayed. 3. Transfer the data from the cell phone. For details about transferring the data, refer t ...
WARNING: ● It is dangerous to drive with the tailgate (upper gate and lower gate) open, since carbon monoxide (CO) gas can enter the cabin. You cannot see or smell CO. It can cause unconsc ...