Jeep Liberty: Rear Window Wiper/Washer
The rear wiper/washer is controlled by a rotary switch located on the control lever. The control lever is located on the right side of the steering column.
Rear Wiper/Washer Control
Rotate the switch upward to the first detent position for rear wiper operation.
NOTE: The rear wiper operates in an intermittent mode only.
Rotate the switch upward past the first detent to activate the rear washer. The washer pump will continue to operate as long as the switch is held (for a maximum of 10 seconds). Upon release, the wiper will cycle two times before returning to the set position.
If the rear wiper is operating when the ignition is turned OFF, the wiper will automatically return to the вЂњparkвЂќ position. When the vehicle is restarted, the wiper will resume function at whichever position the switch is set.
NOTE: The rear wiper and the rear washer will not operate If the liftgate flipper glass is open.
Front Turn Signal And Front Side Marker Lamp
1. Turn the steering wheel all the way to the right to access the left front turn signal or side marker. Turn the steering wheel all the way to the left to access the right front turn signal or ...
Range (Estimated Distance)
This display shows the estimated distance you can travel on the fuel remaining in the tank. This distance is estimated from the fuel economy you have achieved over the last few miles (kilomet ...
Finding a Station
To select the band, see вЂњAudio SourceвЂќ earlier in this section. Turn the MENU/SEL knob to find a radio station. To select a preset station, touch the FAV button and choose a preset station. Se ...