Ford Escape: Replacing fog lamp bulbs (if equipped) - Replacing headlamp bulbs - Bulb Replacement - Lights - Ford Escape Owner's ManualFord Escape: Replacing fog lamp bulbs (if equipped)

1. Make sure the fog lamp switch is in the off position.
2. From underneath the vehicle, carefully disconnect the electrical connector from the bulb.
3. Remove the bulb from the lamp assembly by pulling out the bulb while squeezing the upper and lower snap clips at the same time.

Install the new bulb in reverse order.

Driver Controls

    Replacing license plate lamp bulbs
    1. Make sure the headlamp switch is in the off position. 2. Press the lever and carefully pry the license plate lamp assembly (located above the license plate) from the liftgate. 3. Rotate the b ...

    See also:

    Towing Tips
    Before setting out on a trip, practice turning, stopping, and backing the trailer in an area located away from heavy traffic. ...

    Unlocking the Tailgate
    If the power door lock system cannot unlock the tailgate, unlock it manually. Place a cloth on the top side of the cover to prevent scratches, then use a small flat-tip screwdriver to rem ...

    Switching off the engine with the vehicle moving
    It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP ...