Jeep Liberty: Security - Garage Door Opener — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Security

It is advised to erase all channels before you sell or turn in your vehicle.

To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased.

The HomeLink Universal Transceiver is disabled when the Vehicle Security Alarm is active.

    Using HomeLink
    To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home ...

    Troubleshooting Tips
    If you are having trouble programming HomeLink , here are some of the most common solutions: • Replace the battery in the original hand-held transmitter. • Press the LEARN button on the Garage ...

    See also:

    Air filtration system
    Replace the filter element according to the replacement schedule as follows. This schedule should be followed to maintain the filter’s dust collection ability. Under extremely dusty conditio ...

    To start the engine
    COMBINATION IGNITION SWITCH o If your Hyundai is equipped with a manual transaxle, place the shift lever in neutral and depress the clutch pedal fully. o If your Hyundai has an automatic transa ...

    Facts about TSA
    • TSA intervenes at speeds above approximately 40 mph (60 km/h) • The DSTC symbol () in the instrument panel will flash when TSA is working • If the driver switches off the DSTC system's ...