Jeep Liberty: Supplemental Active Head Restraints (AHR)
These head restraints are passive, deployable components, and vehicles with this equipment cannot be readily identified by any markings, only through visual inspection of the head restraint. The head restraint will be split in two halves, with the front half being soft foam and trim, the back half being decorative plastic.
How The Active Head Restraints (AHR) Work
The Occupant Restraint Controller (ORC) determines whether the severity, or type of rear impact will require the Active Head Restraints (AHR) to deploy. If a rear impact requires deployment, both the driver and front passenger seat AHRs will be deployed.
When AHRs deploy during a rear impact, the front half of the head restraint extends forward to minimize the gap between the back of the occupantвЂ™s head and the AHR.
This system is designed to help prevent or reduce the extent of injuries to the driver and front passenger in certain types of rear impacts.
NOTE: The Active Head Restraints (AHR) may or may not deploy in the event of a front or side impact.
However if during a front impact, a secondary rear impact occurs, the AHR may deploy based on the severity and type of the impact.
Active Head Restraint (AHR) Components
1 вЂ” Head Restraint Front Half (Soft Foam and Trim)
2 вЂ” Seatback
3 вЂ” Head Restraint Back Half (Decorative Plastic Rear Cover)
4 вЂ” Head Restraint Guide Tubes
All occupants, including the driver, should not operate a vehicle or sit in a vehicleвЂ™s seat until the head restraints are placed in their proper positions in order to minimize the risk of neck injury in the event of an accident.
NOTE: For more information on properly adjusting and positioning the head restraint, refer to вЂњAdjusting Active Head RestraintsвЂќ in вЂњUnderstanding The Features Of Your VehicleвЂќ.
Resetting Active Head Restraints (AHR)
If the Active Head Restraints are triggered in an accident, you must reset the head restraint on the driverвЂ™s and front passenger seat. You can recognize when the Active Head Restraint has been triggered by the fact that they have moved forward (as shown in step three of the resetting procedure).
1. Grasp the deployed AHR from the rear seat.
Hand Positioning Points On AHR
2. Position the hands on the top of the deployed AHR at a comfortable position.
3. Pull down then rearward towards the rear of the vehicle then down to engage the locking mechanism.
1 вЂ” Downward Movement
2 вЂ” Rearward Movement
3 вЂ” Final Downward Movement To Engage Locking Mechanism
4. The AHR front soft foam and trim half should lock into the back decorative plastic half.
AHR In Reset Position
вЂў If you have difficulties or problems resetting the Active Head Restraints, see an authorized dealer.
вЂў For safety reasons, have the Active Head Restraints checked by a qualified specialist at an authorized dealer.
Stop the vehicle immediately
The following warning indicates the possibility of damage to the vehicle that may lead to an accident. Immediately stop the vehicle in a safe place and contact your Toyota dealer. ...
Moonroof вЂ“ if the moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the moonroof manually. 1. Remove the plug on the roof trim of the cargo area by inserting the end of the flathead sc ...
Opening the fuel-filler door
Opening the fuel-filler door To open the fuel-filler door, pull the left side of the door. ...