Jeep Liberty: To Arm The System
1. Remove the key from the ignition switch and exit the vehicle.
2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) transmitter.
NOTE: The Vehicle Security Alarm will not arm if you lock the doors with the manual door lock plungers or the driverвЂ™s door lock cylinder.
3. Close all doors. The Vehicle Security Light in the instrument cluster will flash rapidly for about 16 seconds to signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the liftgate will cancel the arming process. If the Vehicle Security Alarm is set successfully, the Vehicle Security Light will flash at a slower rate to indicate the alarm is armed.
NOTE: For added security, whenever the Security Alarm is armed, the HomeLink /Garage Door Opener (if equipped) is disabled as well.
Use the air outlets, located in the center and on the side of the instrument panel, to direct the airflow. Use the thumbwheels located near the center air outlets, to open or close off the airflow ...
Operating the passengersвЂ™ windows
Operating the passengersвЂ™ windows To open: Push the appropriate switch down and hold it until the window reaches the desired position. To close: Pull the switch up and hold it until the ...
Automatic Locking Retractor Mode (ALR) вЂ” If Equipped
In this mode, the shoulder belt is automatically prelocked. The belt will still retract to remove any slack in the shoulder belt. The Automatic Locking Mode is available on all passenger-seating ...