Jeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle

Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shut downs, the system will disable the one-time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.

    To Enter Remote Start Mode
    Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...

    To Exit Remote Start Mode And Drive The Vehicle
    Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key in ...

    See also:

    Locking doors
    1. Turn the ignition switch to the LOCK position.1 2. Carry the Intelligent Key with you. 3. Close all the doors.2 4. Push the door handle request switch (driver’s or front passenger’s) A or ...

    Main power window switch (driver’s side)
    Main power window switch (driver’s side) 1. Window lock button 2. Driver side window 3. Rear left passenger side window 4. Front passenger side window 5. Rear right passenger side window ...

    Setting the temperature
    Different temperatures can be set for the driver's and front-passenger sides. Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: turn controls 1 and 8 clockwise or cou ...