Dodge Nitro: To open and close the hood - Understanding the features of your vehicle - Dodge Nitro Owner's ManualDodge Nitro: To open and close the hood

To open the hood, there are two latches that must be released. 1. Pull the hood release lever located under the left side of the instrument panel.

Hood Release Lever Hood Release Lever

2. Push the safety latch lever to the right. It is located between the grille and hood opening left of the center.

Safety Latch Safety Latch

CAUTION: To prevent possible damage:
• Do not slam the hood to close it.
• Lower the hood to approximately 6 in (15.2 cm) above the closed position and drop the hood to latch it.
• Never drive your vehicle unless the hood is fully closed, with both latches engaged.

NOTE: Ensure hood prop rod is fully seated into clip before closing hood to prevent damage to grille.

WARNING: Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched, it could open when the vehicle is in motion and block your vision. Failure to follow this warning could result in serious injury or death.

    Seats
    Seats are a primary part of the Occupant Restraint System of the vehicle. They need to be used properly for safe operation of the vehicle. WARNING: • Do not allow people to ride in any area o ...

    Lights
    Multifunction Lever The multifunction lever controls the operation of the parking lights, headlights, headlight beam selection, passing light, fog lights, instrument panel light dimming and tur ...

    See also:

    Tire change procedure
    WARNING: When one of the front wheels is off the ground, the transmission alone will not prevent the vehicle from moving or slipping off the jack, even if the vehicle is in P (Park) (automatic tra ...

    Limited-Use Spare – If Equipped
    The limited-use spare tire is for temporary emergency use only. This tire is identified by a label located on the limited-use spare wheel. This label contains the driving limitations for this sp ...

    Head Restraints
    Head restraints are designed to reduce the risk of injury by restricting head movement in the event of a rear impact. Head restraints should be adjusted so that the top of the head restraint is ...