Honda CR-V: To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select.

TUNE - Use the SEEK button to tune to a desired frequency. Press the frequency, and the  button to button to tune to a higher frequency, and the tune to a lower frequency. button to tune to a lower frequency.

You can also operate the tune function by using the VOL/SELECT knob. Press the VOL/SELECT knob and you will see ‘‘SEL’’ in the display.

Turn the knob right to tune to a higher frequency, or left to tune to a lower frequency. To turn it off, press the VOL/SELECT knob or button. button, or The system will return to the normal button.

The system will return to the normal display about 10 seconds after you stop adjusting the tune mode.

SEEK - The SEEK function searches up and down from the current frequency to find a station with a strong signal. To activate it, press and hold the side or side side of the SEEK button until you hear a beep, then release it.

SCAN - The scan function samples all stations with strong signals on the selected band. To activate it, press the SCAN button, then release it.

You will see SCAN in the display.

When the system finds a strong signal, it will stop and play that station for about 10 seconds.

If you do nothing, the system will then scan for the next strong station and play it for 10 seconds. When it plays a station you want to listen to, press the SCAN button again.

Preset - Each preset button can store one frequency on AM and two frequencies on FM.

1. Select the desired band, AM or FM.

2. Use the tune, seek, or scan function to tune the radio to a desired station.

3. Pick a preset number (1 - 6), and hold it until you hear a beep.

4. Repeat steps 1 through 3 to store a total of six stations on AM and twelve stations on FM.

AUTO SELECT - If you are traveling and can no longer receive your preset stations, you can use the auto select feature to find stations in the local area.

Press the A. SEL button. ‘‘A. SEL’’ flashes in the display, and the system goes into scan mode for several seconds. It stores the frequencies of six AM and twelve FM stations in the preset buttons.

You will see a ‘‘0’’ displayed after pressing a preset button if auto select cannot find a strong station for that preset button.

If you do not like the stations auto select has stored, you can store other frequencies on the preset buttons as previously described.

To turn off auto select, press the A. SEL button. This restores the presets you originally set.

For information on FM/AM radio frequencies and reception.

READ NEXT:

 Adjusting the Sound

Press the sound ( ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu

 Playing the XM Radio

On EX-L without Navigation System Your vehicle is capable of receiving XM Radio anywhere in Canada and the United States, except Hawaii, Alaska, and Puerto Rico. XM CANADA is a registered bus

SEE MORE:

 Towing a Trailer

Your vehicle has been designed primarily to carry passengers and their cargo. You can also use it to tow a trailer if you carefully observe the load limits, use the proper equipment, and follow the guidelines in this section. Break-In Period Avoid towing a trailer during your vehicle

 Tire Rotation

To help increase tire life and distribute wear more evenly, rotate the tires according to the maintenance messages displayed on the information display.Move the tires to the positions shown in the diagram each time they are rotated. If you purchase directional tires, rotate only fro

В© 2016-2020 Copyright www.hcrv.net